Grail Light

Christopher antoniou holyglobe03
Christopher antoniou holyglobe01
Christopher antoniou holyglobe02

ledTreePrint

straightTree

fiberOptics

Christopher antoniou holyglobe05
Christopher antoniou holyglobe04
Christopher antoniou holyglobe06

There is my latest print from the Raise 3D N2 plus. I went into one of England's special forests and did a photogrammetry of a tree then manipulated it in zbrush into a grail with tubes inside to pass fibre optic throw. The print took 12 hour at 100 microns and was about 10cm x 20cm x 10cm. After threading all the fibre optic I used led's connected to with batteries to light the cables up. Back in the magical woods again and having a crystal ball to hand I took some photos with an SLR with a 50 mm lens. And there you have my grail Light , which I am hoping to cast into metal soon.